moon ACE NEO SERIES Owner's Manual page 18

7. The next setup option in the "CONFIG" section is "NET PARAMETERS". Similarly to "WiFi PARAMETERS", there is an
"AUTOMATIC" option (default setting) and a "MANUAL" option:
Note: The "AUTOMATIC" option for "NET PARAMETERS" (DHCP) will cover 99% of all scenarios.
8. Alternatively, you can perform this process manually. The "MANUAL" option should ONLY be performed by someone
who has a complete understanding about how to configure a network; From the aforementioned "NET
PARAMETERS" screen, rotate the volume control to highlight the "MANUAL" option and then press "OK". Here you
will have to manually input a series of network parameters (all numeric) using the "
control, and finally the "OK" button to go to the next required network parameter (displayed screen). The four (4)
required network parameters are "IP Address", "Net Mask", "Gateway Address" and "DNS address". Once all settings
are entered, you will be prompted to save these "NETWORK PARAMETER" settings:
9. The "INFO" feature will display all the information about your network's configuration; Since there are eight (8) items
to display, you will have to use the volume control to scroll the display up and down to view all settings (notice the
previously described arrows located on the far right of the display,
10. The "MiND UPDATE" feature is the final "NETWORK" option and provides a facility to automatically update the MiND
module's firmware. Rotate the volume control to highlight "MiND UPDATE" and press "OK". Then rotate the volume
control to highlight "YES" and press "OK".
Note: If you go to the MiND input during a firmware update has been initiated, a status of this update's
progress will appear at the top of the display window.
18
ACE Nēo
Series
Input
on top and on bottom:
" buttons, the volume