moon ACE NEO SERIES Owner's Manual page 15

Owner's Manual
Note: "MiND" is the only input that cannot be disabled:
9. The fourth configurable option is the volume bypass feature for use with home-theater processors and source
components that have their own volume control. When activated, the volume control of the ACE is bypassed and
the volume is adjusted from the component connected to the input. This option is only available for the "ANALOG 1"
and "ANALOG 2" inputs.
To enable this setting you must first go to either "ANALOG 1" or "ANALOG 2" in the "INPUTS" section of the SETUP
menu. Then rotate the volume control until "HT BYPASS" is highlighted on the display. Press "OK" and "NORMAL"
will appear highlighted on the display. Rotate the volume until "HT BYPASS" is highlighted, then press OK:
The message "Are you sure you want to enable HT Bypass?" followed on the next line by "NO" (highlighted) and
"YES" on the display. Rotate the volume control to highlight "YES", then press OK. The "HT BYPASS" option is now
active for the "ANALOG 1" input:
Note: When you enable "HT BYPASS", the volume "OFFSET" you previously saved for this input will be set to
0.0dB to create a 0.0dB of gain from input to output; The "OFFSET" can then be adjusted if required. When
this "HT BYPASS" is disabled, the "OFFSET" will automatically be reset to its default value of 6.0dB.
10. At this point you can return to the "INPUTS" main menu and configure another input by pressing the "SETUP" button
twice and then selecting another input; You can return to the main "SETUP" menu by pressing the "SETUP" button a
third time; You can exit from "SETUP" by pressing the "SETUP" button a fourth time – "EXITING" will briefly appear on
the display:
To summarize which options are available for each of the eleven (11) inputs refer to the following chart.
INPUT
OPTICAL 1
OPTION OPTICAL 2
LABEL:
PRESET NAME
CUSTOM NAME
OFFSET
ENABLE / DISABLE
HT BYPASS
SPDIF 1
USB MiND
SPDIF 2
ANALOG 1
BLUETOOTH
ANALOG 2
PHONO MP IN
15