Before you begin:
v Read "Safety information" on page 113.
v Review the information in "Before you begin" on page 29.
To remove the handle cap, do the following:
1. Power-off the computer, if it is on.
2. Unplug the computer.
3. Remove the drive cage (see "Drive cage removal" on page 72).
4. Remove the speaker/fan bracket (see "Speaker/fan bracket removal" on
5. Disconnect the control panel from the system board.
6. Depress the tab and pull the control panel back away from the chassis to
Type 6846 removals
Handle assembly removal
Before you begin:
v Read "Safety information" on page 113.
v Review the information in "Before you begin" on page 29.
Note: It is recommended that the computer be placed on its left side before
To remove the handle cap, do the following:
1. Power-off the computer, if it is on.
2. Unplug the computer.
3. Use a flathead screwdriver to gently press in and down on the tabs located on
4. Lift up on the handle cap to separate it from the handle support.
To remove the handle support, do the following:
1. Power-off the computer, if it is on.
2. Unplug the computer.
3. Firmly grasp the handle support and slide it away from the front bezel.
4. Lift up on the handle support to remove it from the slots in the top of the
page 75).
remove.
performing this service procedure. Rotate the feet in toward the computer so
they do not detach due to the weight of the computer.
the interior side wall of the handle.
chassis.
Chapter 6. FRU information (service only)
77