Table of Contents
Advertisement
Chapter 4. Configuration
Using the Configuration/Setup Utility program .
Starting the Configuration/Setup Utility program 23
Choices available from the Configuration/Setup
Utility main menu .
The following configuration programs are provided with your computer:
v Configuration/Setup Utility program
v SCSISelect Utility program (some models)
Using the Configuration/Setup Utility program
This section provides the instructions for starting the Configuration/Setup Utility
program and descriptions of the menu choices that are available.
Starting the Configuration/Setup Utility program
Complete the following steps to start the Configuration/Setup Utility program:
1. Turn on the computer and watch the monitor screen.
2. When the message, Press F1 for Configuration/Setup, appears, press F1.
3. Follow the instructions that appear on the screen.
Choices available from the Configuration/Setup Utility main
menu
From the Configuration/Setup Utility main menu, you can select settings that you
want to change. The Configuration/Setup Utility main menu is similar to the
© Copyright IBM Corp. 2000
.
.
.
.
.
.
.
.
.
This program is part of the BIOS code that comes with your computer. You can
use this program to configure serial- and parallel-connector assignments, change
the drive startup sequence, set the date and time, and set passwords. See "Using
the Configuration/Setup Utility program" on page 23 for more information.
With the built-in SCSISelect Utility program, you can configure the devices that
are attached to the optional SCSI adapter. See "Using the SCSISelect Utility
program (some models)" on page 26 for more information.
. 23
Using passwords
Using the SCSISelect Utility program (some models) 26
Starting the SCSISelect Utility program .
. 23
Choices available from the SCSISelect menu
.
.
.
.
.
.
.
.
.
.
.
. 26
.
. 26
.
. 26
23
Advertisement
Table of Contents
