Led/Power Switch Assembly Removal - IBM IntelliStation 6836 Hardware Maintenance Manual

7. Unplug the speaker from the system board.
8. Gently push the tabs of the I/O card retainer assembly in to release; lift it up
9. Slide the speaker up and out of the computer.

LED/power switch assembly removal

Before you begin:
v Read "Safety information" on page 113.
v Review the information in "Before you begin" on page 29.
Note: It is recommended that the computer be placed on its left side before
To remove the button kit, do the following:
1. Power-off the computer, if it is on.
2. Unplug the computer.
3. Remove the cover (see "Removing the side cover" on page 48).
4. Remove the front bezel (see "Front bezel removal" on page 78).
5. Remove the hot-swap hard disk drive (see "Hard drive cage removal" on
6. Disconnect the cable of the button kit from the system board.
7. Place a screwdriver against the bottom release latch of the button kit and gently
8. Gently pinch together the upper release latches and slide the latches through
86
Hardware Maintenance Manual: IBM IntelliStation Type 6836, 6846
and out of the computer.
performing this service procedure. Rotate the feet in toward the computer so
they do not detatch due to the weight of the computer.
page 82).
press upward and slide the latch through the aperture.
the aperture and remove the button kit.