Table of Contents
Advertisement
Diagnostic Error Code
005-010-XXX 005-011-XXX 005-012-XXX
005-013-XXXVideo Signal failure
005-016-XXXVideo Simple Pattern test failure 1. Video Ram
005-024-XXXVideo Addressing test failure
005-025-XXXVideo Checksum Value error
005-027-XXXVideo Configuration/Setup
error
005-031-XXXVideo Device Cable failure
005-032-XXXVideo Device Controller failure
005-036-XXXVideo Register error
005-038-XXXSystem BIOS extension failure
005-040-XXXVideo IRQ failure
005-195-XXXVideo Test aborted by user
005-196-XXXVideo test halt, error threshold
exceeded
005-197-XXXVideo test warning
005-198-XXXVideo test aborted
FRU/Action
1. Video card, if installed
2. System board
2. Video card, if installed
3. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Run Setup
2. Video drivers update
3. Video card, if installed
4. System board
1. Video cable
2. Monitor
3. Video card, if installed
4. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Information
2. Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called
out is connected and/or enabled
2. Re-run test
3. Component that is called out in warning
statement
4. Component under test
1. If a component is called out, make sure
it is connected and/or enabled
2. Flash the system and re-test
3. Go to the "Undetermined problems"
section
Chapter 7. Symptom-to-FRU index
91
Advertisement
Table of Contents
