IBM IntelliStation 6836 Hardware Maintenance Manual page 100

92
Hardware Maintenance Manual: IBM IntelliStation Type 6836, 6846
Diagnostic Error Code
005-199-XXXVideo test failed, cause
unknown
005-2XX-XXX 005-3XX-XXXVideo subsystem
error
006-000-XXXDiskette interface Test Passed
006-0XX-XXXDiskette interface error
006-195-XXXDiskette interface Test aborted
by user
006-196-XXXDiskette interface test halt, error
threshold exceeded
006-197-XXXDiskette interface test warning
006-198-XXXDiskette interface test aborted
006-199-XXXDiskette interface test failed,
cause unknown
006-25X-XXXDiskette interface Error
011-000-XXXSerial port Interface Test Passed
011-001-XXXSerial port Presence
011-002-XXX 011-003-XXXSerial port
Timeout/Parity error
011-013-XXX 011-014-XXXSerial port Control
Signal/Loopback test failure
011-015-XXXSerial port External Loopback
failure
FRU/Action
1. Go to the "Undetermined problems"
section
2. Flash the system and re-test
3. Replace component under function test
1. Video card, if installed
2. System board
1. No action
1. Diskette drive Cable
2. Diskette drive
3. System board
1. Information
2. Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. If a component is called out, make sure
it is connected and/or enabled
2. Re-run test
3. Component that is called out in warning
statement
4. Component under test
1. If a component is called out, make sure
it is connected and/or enabled
2. Flash the system and re-test
3. Go to the "Undetermined problems"
section
1. Go to the "Undetermined problems"
section
2. Flash the system and re-test
3. Replace component under function test
1. Diskette drive cable
2. Diskette drive
3. System board
1. No action
1. Remove external serial device, if
present
2. Run setup, enable port
3. System board
1. System board
1. System board
1. Wrap plug
2. System board