Installing A Security U-Bolt - IBM IntelliStation 6836 Hardware Maintenance Manual

10. Replace the support bracket assembly and reconnect the fan cable to the
11. Replace the side cover, see "Installing the cover" on page 61.
12. Reconnect the external cables and power cords, and turn on the attached
If you want to remove a DIMM, reverse the steps.

Installing a security U-bolt

To help prevent hardware theft, you can add a security U-bolt and cable to your
computer. After you add the security cable, make sure that it does not interfere
with other cables that are connected to the computer.
60
Hardware Maintenance Manual: IBM IntelliStation Type 6836, 6846
Note: To avoid breaking the retaining clips or damaging the DIMM
connectors, open and close the clips gently.
c. Insert the DIMM into the connector by aligning the DIMM edges with the
slots at each end of the DIMM connector. Firmly press the DIMM straight
down into the connector by applying pressure on both ends of the DIMM
simultaneously. Be sure that the retaining clips snap into the locked
position when the DIMM is firmly seated in the connector.
d. If a gap exists between the DIMM and the retaining clips, the DIMM has
not been correctly installed. In this case, open the retaining clips and
remove the DIMM; then, reinsert the DIMM.
8. If you removed the AGP adapter, reinstall it now, see "Installing an adapter"
on page 51.
9. If you have other options to install or remove, do so now.
connector (SYSFA3) on the system board. See "Removing the support bracket
assembly" on page 48 for removal instructions.
devices and the computer.