IBM IntelliStation 6836 Hardware Maintenance Manual page 50

Statement 3
10. If you are installing a drive in drive bay 3, attach the blue, plastic guide rails
42
Hardware Maintenance Manual: IBM IntelliStation Type 6836, 6846
Danger
Some laser products contain an embedded Class 3A or Class 3B laser diode. Note the
following. Laser radiation when open. Do not stare into the beam, do not view directly
with optical instruments, and avoid direct exposure to the beam.
Note: If your computer has a CD-ROM drive installed in bay 1, remove the
signal and power cables from the CD-ROM drive before rotating the
drive cage out of the computer.
5. Rotate the drive cage toward the front of the computer until the drive cage
latch locks on the chassis.
Attention: Do not use the drive cage latch to rotate either drive cage out of
the computer.
6. Touch the static-protective bag containing the drive to any unpainted metal
surface on the computer; then, remove the drive from the bag and place it on
a static-protective surface.
7. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
8. Push the drive into the bay; then, use the two screws to attach the drive to the
drive cage.
9. If installing a 3.5-in. drive bay 2, you must attach the 5.25 in. conversion kit,
supplied with your option, to the 3.5-in drive.
to the sides of the drive using the screws provided.
Drive cage
Drive cage
latch