IBM IntelliStation 6836 Hardware Maintenance Manual page 105

Diagnostic Error Code
025-197-XXXIDE interface test warning
025-198-XXXIDE interface test aborted
025-199-XXXIDE interface test failed, cause
unknown
030-000-XXXSCSI interface Test Passed
030-00X-XXX 030-01X-XXXSCSI interface
failure
030-027-XXXSCSI interface
Configuration/Setup error
030-03X-XXX 030-04X-XXXSCSI interface
error
030-195-XXXSCSI interface Test aborted by
user
030-196-XXXSCSI interface test halt, error
threshold exceeded
030-197-XXXSCSI interface test warning
FRU/Action
1. Make sure the component that is called
out is connected and/or enabled
2. Re-run test
3. Component that is called out in warning
statement
4. Component under test
1. If a component is called out, make sure
it is connected and/or enabled
2. Flash the system and re-test
3. Go to the "Undetermined problems"
section
1. Go to the "Undetermined problems"
section
2. Flash the system and re-test
3. Replace component under function test
1. No action
1. SCSI signal cable
2. Check power supply
3. SCSI device
4. SCSI adapter card, if installed
5. System board
1. SCSI signal cable
2. Flash the system
3. SCSI device
4. SCSI adapter card, if installed
5. System board
1. SCSI signal cable
2. Check power supply
3. SCSI device
4. SCSI adapter card, if installed
5. installed System board
1. Information
2. Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called
out is connected and/or enabled
2. Re-run test
3. Component that is called out in warning
statement
4. Component under test
Chapter 7. Symptom-to-FRU index
97