Troubleshooting - Nortel FastRad Installation Manual

Troubleshooting

Troubleshooting the FastRAD installation is needed if you start
a programming session and the display shows
Inactive feature.
1. Check the wiring at the distribution block.
2. Make sure the Norstar port that the FastRAD is attached to
is working.
3. Check that the power LED on the FastRAD unit is lit to
confirm the power connection.
4. Refer to the appropriate Norstar Installer Guide for further
diagnostic tests.
Note: If the wiring at the distribution block has been discon-
nected, the FastRAD can take up to two minutes to reset after
the wiring is reconnected.
After you have checked all the wiring:
ƒ·••
1. Press
The display should show:
2. Press NEXT.
The display shows:
If the display is still showing Inactive feature, repackage
the FastRAD, and return it to the point of purchase.
.
Enter password
EXIT CHNG NEXT
RAD Admin
GEN ALARM DATA
FastRAD Installation Guide
21