Nortel FastRad Installation Manual page 27

Programming
Data
This completes alarm programming. To continue programming
FastRAD call handling, refer to the next section, Programming
Data.
Data programming allows you to determine how many seconds
the FastRAD waits before answering a call on an incoming KSU
line. This allows a line to be used normally during business
hours and provides Auto-answer capabilities after hours. Auto-
answer must be set to ON to allow unassisted access to the
FastRAD.
Before you begin programming, make sure the display shows
RAD Admin.
If you do not have this display on the Norstar telephone, follow
the steps in Starting a Programming Session.
To program the FastRAD's Data:
1. Press DATA.
The display shows:
2. Press CHNG to turn automatic answer ON.
The display shows:
3. Press NEXT.
The display shows:
4. Press CHNG.
The display shows:
5. Enter the KSU line number the FastRAD uses for remote
connections. Refer to the Programming Record for the
correct line number.
Auto-answer: OFF
BACK CHNG NEXT
Auto-answer: ON
BACK CHNG NEXT
Answer line: 001
BACK CHNG NEXT
Answer line:_
CLEAR BKSP
FastRAD Installation Guide
17
OK