Programming Record - Nortel FastRad Installation Manual

22
Programming
Record
FastRAD Programming Record
Work Site: _______________________________________________________________
Address: ________________________
________________________
________________________
Notes: _______________________________________________________________
GENERAL
System ID
Number __________
ALARM
Auto- Off
report On
Report
Line __________
Alarm
Number 1 __________
Alarm
Number 2 __________
Retry
Delay __________
Number
of Retries __________
Alarm Low
Baud Medium
High
Parity None
Odd
Even
DATA
Auto- Off
answer On
Answer
Line __________
FastRAD Installation Guide
Complete the FastRAD Programming Record before you start
programming.
Enter the System ID number. (Disable Admin if required.)
Choose if you want the FastRAD to report alarms. The default is
Off.
Enter the line number. Enter a number between 001 and 999.
The default is 001.
Enter the telephone number of the device where the FastRAD
reports alarms.
Enter the telephone number of a second device where the
FastRAD reports alarms.
Enter the number of minutes the FastRAD waits before it retries
to report an alarm. Enter a number between 1 and 99.
Enter how many times a FastRAD tries to send an alarm after a
failed connection attempt. Enter a number between 0 and 9.
Choose the alarm baud number. The default is High.
Choose which parity setting the FastRAD uses. The default is
None.
Choose if you want the FastRAD to answer incoming calls
(must be ON to allow remote, unassisted access). The default is
Off.
Enter the line number. An on-core KSU line is recommended.
Enter a number between 001 and 999. The default is 001.
Telephone Number: __________________
Installation Date:
Installer:
__________________
__________________