Table of Contents
Advertisement
10. Press CHNG until the display shows the desired local serial
port baud rate (300, 1200, 2400, 4800, 9600 or 19200).
Note: To use Norstar Manager in a direct connection, the
local baud rate must be set to 9600 baud.
11. Press NEXT.
The display shows:
®
12. Press
to end programming.
The FastRAD programming is completed. You must now test
the FastRAD to make sure it is operating properly.
RAD Admin
GEN
ALARM
DATA
FastRAD Installation Guide
19
Hide quick links:
Advertisement
Table of Contents
