Back Thermal Insulation Panel Installation; Placement Of Ember Glass On The Burner - J. A. Roby loo RGR-25 Installation And Operation Manual

8.5.2. BACK THERMAL INSULATION PANEL INSTALLATION

Screws are already in place and included with your appliance. Untighten it not completely. Two groves are
cut into the tabs to insert it easily.
Put the tab behind the bottom frame
align the screws into the grooves and
it enough to keep in place the thermal
insulation panel (Figure 8.5.2)

8.6. PLACEMENT OF EMBER GLASS ON THE BURNER

For optimal combustion, you must spread the mandatory required amount of ember glass (2 cups) on
the burner.
Ember glass is provided with your device. Always wear gloves to prevent cutting yourself on the glass.
After handling ember glass, carefully wash your hands with soap and water to remove all traces of glass.
The proper positioning of
glass must be distributed evenly over the burner. Do not add additional
vermiculite. Use only the amount of

Remove the frame of the window. Refer to section 8.3.1 REMOVING THE DOOR

Carefully open the bag containing the ember glass.

Spread ember glass carefully on top of the burner. Use the entire bag and distribute it evenly over the
entire surface of the burner so as to cover the entire plate and grooves.
71
WARNING
ember glass is essential to good and safe operation of the appliance. Ember
ember glass
Figure 8.5.2
WARNING
provided with the appliance.
tighten
ember glass, ornaments or
and