Table of Contents
Advertisement
8.5.2
8.5.2 BACK THERMAL INSULATION PANEL INSTALLATION
Screws are already in place and include with
your appliance. Untighten it not completely.
Two groves are cut into the tabs to insert it
easily.
Put the tab behind the bottom frame and
align the screws into the grooves and tighten it
enough to keep in place the thermal insulation
panel (Figure 8.5.2)
8.6
PLACEMENT OF EMBER GLASS ON THE BURNER
WARNING:
For optimal combustion, you must spread the mandatory required amount of ember glass (2 cups) on the burner.
Ember glass is provided with your device. Always wear gloves to prevent cutting yourself on the glass. After
handling ember glass, carefully wash your hands with soap and water to remove all traces of glass.
WARNING:
The proper positioning of
must be distributed evenly over the burner. Do not add additional
only the amount of
ember glass
• Remove the frame of the window. Refer to section 8.3.1 REMOVING THE DOOR
• Carefully open the bag containing the ember glass.
• Spread ember glass carefully on top of the burner. Use the entire bag and distribute it evenly over the entire
surface of the burner so as to cover the entire plate and grooves.
9.
MAINTENANCE
9.1
PRECAUTION
A certified technician should perform the annual inspection and maintenance of your fireplace in addition to the
general installation of the fireplace and vent system to keep everything up and running safely. The gas intake
should be cut and the fireplace should be completely cool during any maintenance. All parts of equipment that
are set aside for maintenance must be secured before the next use.
ember glass
is essential to good and safe operation of the appliance. Ember glass
provided with the appliance.
Figure 8.5.2
ember
glass, ornaments or vermiculite. Use
65
Advertisement
Table of Contents
