Table of Contents
Advertisement
3. GAS FIREPLACE INSTALLATION
Before starting the installation of the fireplace, make sure to read and understand section 1.2.1 describing
the safety precautions to take when installing this appliance.
This device is designed to operate with a remote control or a wall switch.
When planning the fireplace installation you must determine:
Where the appliance will be installed.
The ventilation system configuration you will use.
Make sure to check that it complies with the formulas
listed in section 0 VENT INSTALLATION.
The configuration of the gas supply pipe.
The configuration of the electrical wiring.
The configuration of the recessed installation.
The finishing details.
The list of tools and installation equipment required.
Inspect thoroughly the unit and its components. Report any damaged component to the merchant.
3.1. INSERT INSTALLATION OF THE GAS FIREPLACE
• The framework should rest on top of the fireplace's upper clearance post as well as on the air circulation
boxes located on the sides and at the back of the unit (see section 3.1.4 TOP CLEARANCE.)
• The fireplace can be installed directly on a hard combustible floor (see section 1.2.1) or on a platform
with an appropriate height. Do not place the fireplace on carpeting, vinyl or other soft floor coverings. You
can however install it on wood floor, plywood, particle board or other hard surfaces. Make sure the unit is
placed on a continuous floor or a sturdy platform and that the framework offers adequate support. No cold
air should enter the room from under the fireplace.
No matter which vent system configuration you choose, you must absolutely install an insulating sleeve
over the first 8 ft. of vent, no exception. Always use the fireguard provided with the gas fireplace when
the vent is protected by the 8 ft. insulating sleeve and it goes through a wall/floor/ceiling/etc.
22
WARNING
Advertisement
Table of Contents
