Table of Contents
Advertisement
3.2.3.6. W
ALL VENT INSTALLATION
Figure 3.2.3.5.a
Install the ventilation system in accordance with the manufacturer's instructions included with the
components. (See 3.2.3).
Install the unit in the desired location. Check to determine if studs, structural walls or rafters could pose a
problem when fastening the vent system.
The flexible horizontal vent lengths must be supported every 3 ft. (90 cm). Wall ties are provided for this
purpose. The vent support can be used to fasten both hard and flexible vents.
A fireguard is included with the fireplace; it is adapted to receive both the vent and the insulating sleeve
that covers the first 8 ft. of vent.
If the first 8 ft. of vent must go through a wall, cut out an 11.75 x 11.75 in. (30 x 30 cm) square hole or an
Ø11.75 in. hole and use the fireguard provided with the fireplace.
38
Advertisement
Table of Contents
