Table of Contents
Advertisement
4.2.2. REMOTE CONTROL SETTING
Figure 4.2.2.a
Temperature display:
With the system off, press both THERMOSTAT and MODE buttons at the same time (see figure 4.2.2.a).
Check the remote control's LCD screen; a °C or °F symbol should have appeared at the right of the number
indicating room temperature (see figure 4.2.2.b).
Remote control of flame:
The PROFLAMME 2 system has six (6) flame intensity levels. When the system is on and the flame is at
its maximum level, each push on the downward arrow button (see figure 4.2.2.a) will bring flame height
one level lower until it there is no longer any flame.
The upward arrow button (see figure 4.2.2.a) increases flame height one level each time you push it. If
you press the upward arrow button when the system is on CPI mode (see section regarding IPI/CPI
modes), you will turn on the main burner at level six (6). Command reception is always confirmed by an
audible beep.
Figure 4.2.2.b
51
Advertisement
Table of Contents
