Fire Hazard - J. A. Roby loo RGR-25 Installation And Operation Manual

 Explain the risks related to the fireplace's high temperature to both children and adults.

Do not use the appliance without a protection system in the presence of small children.

Keep the appliance dry (mold and rust can cause odors and water could damage the controls).

Make sure the air inlets and the service access door are clear and uncluttered.

If any part of the fireplace is exposed to or immersed in water, refrain from using the appliance and
contact a qualified technician as soon as possible to have the damaged elements repaired or replaced.

If a log, a brick panel or any other accessory is damaged, do not use the fireplace until a qualified
technician has replaced it.

This direct-vented gas fireplace is balanced and sealed. About 10 to 20 minutes of operation are
required to stabilize the flame.

Do not use any accessory that has not been recommended by J. A. ROBY.

Do not add a fan, heat exchanger, or any other accessory that has not been approved for use with this
fireplace.
Do not use the fireplace if a glass door is missing, cracked or broken.

When the fireplace is not in use, it is recommended to place the control valve in the off position
(CLOSE).

Inspect the unit and its components to detect any damage; damaged parts may interfere with proper
operation.

This fireplace reaches high temperatures. To avoid burns and clothing catching fire, refrain from
touching hot surfaces. The fireplace will remain hot even after it is turned off. Never touch surfaces
before they have cooled down.

Supervise small children closely and make sure they do not touch or operate the gas fireplace. This
fireplace is designed for space heating; never use it for cooking or burning anything.

This fireplace is designed to be used with the type of gas indicated on the rating plate; never use solid
fuel (wood, coal, paper, cardboard, or other).

Do not use this appliance if any part has been immersed in water or any other liquid. Call a qualified
service technician immediately to have the appliance inspected and to replace any part of the control
system and any gas control mechanism that has been immersed.
For optimal combustion, the mandatory amount of glass (2 cups) on the burner is necessary.

1.2.3. FIRE HAZARD

• Cladding materials must be properly installed to prevent the risk of fire.
• Make sure that no debris are blocking the cap since restricted air flow affects gas combustion.
• Close the manual shutoff valve before installing the devices to test valve pressure. These tests must be
performed by a qualified technician.
• Do not store or use gasoline, any other flammable vapors or liquids in the vicinity of the unit.
• If the gas intake pressure at the valve is too high, it may cause overheating.
• Verify minimum gas intake pressure when other household gas appliances are operating. These
verifications must be performed by a qualified technician.
11
WARNING
:
WARNING: