Remote Control And Fireplace Synchronization - J. A. Roby loo RGR-25 Installation And Operation Manual

Remote control's LCD screen:

4.2.1. REMOTE CONTROL AND FIREPLACE SYNCHRONIZATION

The remote control and the receiver are radio frequency devices. Placing the receiver in or near
metal may considerably reduce the range of the signal.

Push button 1 (figure 4.2.1.b) completely to the right.

Remove a battery from the remote control (figure 4.2.1.a)

Press the PRG button (button 2 in figure 4.2.1.b). You will hear three beeps.

Place the battery back in the remote control. You will hear three beeps again.

Put button 1 (figure 4.2.1.b) back in the center position.

The remote control is now synchronized.

Press the ON/OFF button on the remote control to turn the fireplace on (figure
4.2.2.).
50
CAUTION
Figure 4.2.1.a
Figure 4.2.1.b