Table of Contents
Advertisement
4.2.2
REMOTE CONTROL SETTING
Figure 4.2.2.a
Temperature display:
With the system off, press both THERMOSTAT and MODE buttons at the same time (see figure 4.2.2.a). Check
the remote control's LCD screen; a °C or °F symbol should have appeared at the right of the number indicating
room temperature (see figure 4.2.2.b).
Remote control of flame:
The PROFLAMME 2 system has six (6) flame intensity levels. When the system is on and the flame is at its
maximum level, each push on the downward arrow button (see figure 4.2.2.a) will bring flame height one level
lower until it there is no longer any flame.
The upward arrow button (see figure 4.2.2.a) increases flame height one level each time you push it. If you press
the upward arrow button when the system is on CPI mode (see section regarding IPI/CPI modes), you will turn
on the main burner at level six (6). Command reception is always confirmed by an audible beep.
Figure 4.2.2.b
47
Advertisement
Table of Contents
