Remote control's LCD screen:
CAUTION:
The remote control and the receiver are radio frequency devices. Placing the receiver in or near metal may
considerably reduce the range of the signal.
4.2.1
REMOTE CONTROL AND FIREPLACE SYNCHRONIZATION
• Push button 1 (figure 4.2.1.b) completely to the right.
• Remove a battery from the remote control (figure 4.2.1.a)
• Press the PRG button (button 2 in figure 4.2.1.b). You will hear three beeps.
• Place the battery back in the remote control. You will hear three beeps again.
• Put button 1 (figure 4.2.1.b) back in the center position.
• The remote control is now synchronized.
• Press the ON/OFF button on the remote control to turn the fireplace on (figure 4.2.2.).
Figure 4.2.1.b
Figure 4.2.1.a
46