3Com 6040 Installation Manual page 44

3Com Router 6000 Family
Installation Manual
Step 5: Click <Browse>. Select the file to be downloaded and set protocol to Xmodem.
Click <Send>. The following interface pops up:
Figure 5-2 Load the file using Xmodem
Step 6: After completing download, the system begins writing data to Flash memory,
and then displays the following information on the screen:
Download completed.
Then, the system asks you to select a file type:
please select file to be saved as
1. main application file
2. backup application file
3. secure application file
4. cancel downloading
Enter your choice(1-4):
After you select an option, the system begins writing the file to Flash memory.
Writing to flash memory...
Please waiting,it need a long time (about 5 min).
Write Flash Success.
Please return to 9600 bps. Press ENTER key to reboot the system.
Change the baud rate of the console terminal to 9600 bps, disconnect and re-dial. Then you
can see the system boot banner.
3Com Corporation
5-6
Chapter 5
Maintaining Software