To Configure Remote Access Packages; Srg Pstn Access; Remote Access Package For Voip Trunks - Nortel SRG50 Configuration Manual

Survivable remote gateway

Hide thumbs Also See for SRG50:

Configuration manual (222 pages)

Configuration manual (111 pages)

Table Of Contents

100

101

102

Table of Contents

Chapter 6 Setting up the private VoIP network

h In the adjacent Absorbed Length field, select the number of digits to be absorbed. The

Absorbed Length applies to the digits of the destination code only.

In the Second Route field, enter 999 (the PSTN route).

In the adjacent Absorbed Length field, select the number of digits to be absorbed.

Depending on the dialing plan, the destination code is integrated with the DN or is dialed as a

prefix to the DN. When a user calls the main office, the SRG examines the destination code to

determine the routing. If the First Route, the VoIP trunks, is unavailable, the call is routed to the

Second Route, the PSTN, and the External Number is called. Because Overflow was selected, if

both the First Route and the Second Route are unavailable, the call is routed using the Normal

Route specified in the Normal Route column of the Destination Codes table. Because Auto was

selected, the routing occurs without manual intervention.

SRG PSTN access

Access to the SRG PSTN is required for:

•

calls to the SRG PSTN from SRG telephones or redirected SRG IP telephones in local

mode

•

calls from the SRG PSTN to redirected SRG IP telephones in normal mode

•

calls from main office telephones to the SRG PSTN, using the VoIP trunks

To achieve this access, a remote access package for the VoIP trunks and a destination code for the

PSTN must be configured.

Remote Access Package for VoIP trunks

The SRG views all calls coming in over the VoIP trunks as remote access calls, even though the

VoIP pathway is a dedicated trunk to another closed system.

To allow tandem dialing from the main office through the SRG PSTN, or to redirect SRG IP

telephones to use the SRG local PSTN, you must specify a remote package that provides access to

the PSTN line pool. This remote package is then assigned to each VoIP trunk.