Nortel SRG50 Configuration Manual page 54

54 Chapter 5 IP telephones setup and configuration
There are three fields that define the password registration process (see the table
registration parameters
Enable registration, Enable global registration password, and Global password.
Table 13 Password registration parameters
Enable registration
Enable global registration
password
Global password
Figure 7 Telephony Resources panel, IP and App Sets
4 Select and enter the values to meet the password requirements of your installation.
5 Set the Auto-assign DNs check box according to the requirements of your installation (if set,
the SRG automatically assigns DNs, see the Device Configuration Guide (NN40020-300) for
details).
NN40140-500 NN40140-500
on page 54):
Must be selected to allow IP telephones to register.
Select if a password is going to be entered in the next
field, Global password.
If selected, the installer must enter the Global password
(below) at the IP telephone before the telephone can be
configured.
Enter the password.
If no password is entered, or the Enable global
registration password is not selected, no password is
required to configure the IP telephone.
Note: Nortel recommends that you synchronize this
password with the CS 1000 password.
Password