Nortel SRG50 Configuration Manual page 25

The figure Process map for installing and configuring an SRG
for installing and configuring an SRG50. The procedures in this document assume that the
following activities have been completed:
• The BCM50, including media bay modules, cabling, telephones, and peripherals, have
been installed.
• BCM50 administration has been set up.
• The basic parameters of the BCM50 have been configured.
• CS1000 main office system has been installed and configured to support SRG.
• The SRG has been connected to the LAN (as required) and WAN (to the main office).
• System functionality has been tested to this point.
• Attached devices have been installed and configured (for information about
configuring IP Phones, see
• Non-SRG-specific networking and device configuration has been completed (for
information about configuring the network, see
page 65).
IP telephones setup and configuration
Setting up the private VoIP network
Chapter 2 SRG50 overview
on page 26 provides a process map
on page 53).
SRG50 Configuration Guide
25
on