To Activate Test Local Mode; Configuration Settings For Redirected Phones; Test Local Mode - Nortel SRG50 Configuration Manual

The disadvantage of the second option is that the installer must configure the target
DN in two places: on the Active Sets panel and on the SRG-specific panels (the
SRG-specific panels must be completed). The SRG looks at the SRG-specific panels
first. It goes to the Active Sets panel only if the VOIP Trunk Access Code has not
been configured.

Configuration settings for redirected phones

The Telephony Device Installation Guide and the Networking Configuration Guide provide
detailed instructions for configuring IP telephones. For IP telephones that are redirected to the
main office call server, incorporate the settings shown in the table
redirected IP telephones
Table 14 Configuration settings for redirected IP telephones
Parameter
S1 IP
S1 Port
S1 Action
S1 Retry Count
S2 IP
S2 Port
S2 Action
S2 Retry Count
For more information, see

Test Local Mode

An IP telephone operating in normal mode can be forced to redirect to the SRG. This allows the
telephone user, and system administrator, to test local mode operation without taking down the
VoIP trunk to the main office.

To activate Test Local Mode

1 From the telephone dialpad, press the Services key
2
Press the Test Local Mode button.
The telephone is now in Test Local Mode.
Chapter 5 IP telephones setup and configuration
on page 61.
CS 1000
SRG IP address
7300
1
1
SRG IP address
7300
1
1
CS 1000 considerations
Configuration settings for
on page 33.
.
SRG50 Configuration Guide
61