Nortel SRG50 Configuration Manual page 45

Table 8 S1000 Main Office Settings (Sheet 2 of 3)
Field
H323 ID
Numbering Plan ID
Type of Number
Values
SRG* (default)
*This setting must be changed.
see the Networking Configuration
Guide (NN40020-603) for naming
conventions.
Unknown
ISDN/Telephony (E.164)
Private
Telephony (E.163)
Telex (F.69)
Data (X.121)
National Standard
Default: Private
Unknown
International Number
National Number
Special Number
Subscriber Number
ESN LOC (UDP)
ESN CDP
ESN Special Number
Default: ESN CDP (for CDP dialing
plans) (BUID = DN)
UDP dialing plans: select ESN
LOC (UDP) (BUID = LOC+DN)
Chapter 4 CS 1000 considerations
Description
Gatekeeper setting that identifies the SRG.
This value must match the value in the Alias
names field of the Local IP gateway:
Configuration > Resources > Telephony
Resources > Modules panel > Module type
column: select IP Trunks > Details for Module:
Internal details panel > Local Gateway tab >
Gatekeeper Support subpanel > Alias names
field (see VoIP trunking configuration
The SRG acts as a SIP endpoint and obtains the
Main Office TPS IP address from the NCS using
the H323 ID.
Configure this field as the same SIP endpoint name
as you configure for the NRS endpoint name. This
is a generic field used for both SIP and H.323
virtual trunk configurations.
The type of numbering plan at the main office.
The main office dialing plan.
Ensure that the SRG private dialing plan is
configured to match the selected value.
SRG50 Configuration Guide
45
on page 72).