Maintenance
DISPLAY CONFIG (D C)
Introduction
The DISPLAY CONFIG or D C command displays the configuration settings of
the active HLC. Configuration includes the following settings:
the card's security level
the card's autoclock setting
the site name (card name)
The HLC's serial number, firmware version, and DIP switch settings also
appear, although this information is not entered with the SET command.
Note: All home office sites served by an HLC have the same configuration
settings.
To display the HLC's configuration settings
1
If you are not already logged in, log in to the MMI.
See "LOGIN (L)" on page 91.
Result: The MMI presents you with the logged-on command prompt.
(See "Command prompts" on page 91.)
102
Standard 01.02
Meridian HomeOffice II