Table of Contents
Advertisement
20 CallPilot resource configuration
Prompt
CSQI
CSQO
4
Defining CallPilot in the customer data block (LD 15)
Tech tip: To view current system parameters, go to LD 21 and enter PRT at
the REQ prompt, and then CDB and the appropriate customer number. The
result is a list of all the current information in the Customer Data Block. Use
the capture text function in hyperterminal to save a text file of the output.
Step
1
2
3
Table 5
LD 15 - Configuring Call Park Allowed and Message Center Included
Prompt
REQ
TYPE
CUST
OPT
IDEF
Copyright © 2007-2008, Nortel Networks
.
Response
xxx
xxx
To exit the overlay, enter ****.
Action
Connect to the PBX.
Enter LD 15.
Enter the appropriate values as described in the following table to
add Call Park Allowed and Message Center Included. For prompts
not listed in the following table, press Enter to accept the default.
Response
CHG
ftr
xx
CPA MCI
YES
NO
Nortel CallPilot
Quickstart Guide
NN44200-313 01.02 Standard
5.0 19 May 2008
Notes
Enter the number of CallPilot
DS0 channels multiplied by 2.
For example, if there are 24
DS0 channels, enter 48.
Enter the number of CallPilot
DS0 channels multiplied by 2.
For example, if there are 24
DS0 channels, enter 48.
—End—
Notes
Customer number for CallPilot.
If Call Forward by Call Type
(CFCT) is enabled on the CS
1000 or M1 switch, enter YES.
Otherwise, enter NO.
Advertisement
Table of Contents
