Nortel CTA 500dm Installation Manual page 72

72 Troubleshooting
AT command problem?
CTA 500 dm On Line Guide
¥ If the cable is faulty or the ICS is down, the attached phone will
also not work.
The CTA 500 dm does not respond to AT commands sent from
your PC.
¥ Make sure that your PC, terminal or other DTE is conÞgured
correctly.
¥ Check the DTE connection. If the DTE is conÞgured as a DCE
you may need a null modem cable.
¥ Check that your PC or DTE is conÞgured to expect CD and CTS
signals. See ÒSerial Interface Control LinesÓ on page 56
more information.
¥ Check that the CTA 500dm is in the command mode.
¥ Check that your PC or DTE is conÞgured to provide a DTR
signal. See ÒSerial Interface Control LinesÓ on page 56
information.
¥ If the LED is ßashing quickly, refer to the
of this document.
¥ Check that the CTA 500dm serial port is set to the correct baud
rate (115200 is required for all cases except during a software
upgrade) using ÒSerial Interface RateÓ on page
Echoed AT commands from the CTA 500 dm do not appear
correctly on your PC, but the response messages appear
correctly.
¥ Check the echo option on your PC.
¥ Disable echo if your PC displays duplicate characters. Enable
echo if your PC does not display any characters.
¥ See ÒSet Local EchoÓ on page 38
AT response messages do not appear correctly on your PC but
AT commands appear correctly.
¥ If numbers are being returned to the PC instead of messages,
change the message code setting on the CTA 500dm. See
ÒVerbose ControlÓ on page 40
numeric responses and indications are shown in
CTA 500dm responsesÓ on page
¥ Make sure that your terminal is operating in full duplex mode
rather than half duplex mode.
ConÞguration
54.
for more information.
for more information. The
ÒNumeric
83.
P0873832 Issue 05
for
for more
section