Nortel CTA 500dm Installation Manual page 40

40 AT commands
Verbose Control
Result Codes
Result Code Suppression Control
Result Codes
CTA 500 dm On Line Guide
The Verbose Control Command
controls the indications sent by the CTA 500dm. A value of 0
instructs the CTA 500dm to send only numeric indications. A value
of 1 instructs the CTA 500dm to send full indications. The default
value is 1.
The numeric responses and indications are shown in
CTA 500dm responsesÓ on page
OK Appears when the value is supported.
ERROR Appears when the selected value is unrecognized or is not
supported.
The Result Code Suppression Control Command
controls the transmission of result codes by the CTA 500dm.
Possible values are shown below.
Value Use
0 result codes sent (default)
1 result codes not sent
OK Appears when the value is 0.
ERROR Appears when the value is unrecognized and the previous
value was 0.
none Appears when the value is 1 and result codes are suppressed.
none Appears when the value is unrecognized and the previous
value was 1.
V[value]
83.
Q[value]
P0873832 Issue 05
ÒNumeric