Nortel CTA 500dm Installation Manual page 56

56 AT commands
Set Stop Bits
Result Codes
Serial Interface Control Lines
CTA 500 dm On Line Guide
The Set Stop Bits Command
sets the number of stop bits on the interface between the CTA 500dm
and the attached computer. The following table shows the supported
values.
Value
0
1
2
OK Appears when the value is supported.
ERROR Appears when the selected value is not recognized or is not
supported.
Change the operation of the control lines on the serial interface by
using AT commands.
&P6=value
Use
one stop bit (default)
one and one-half stop bits
two stop bits
P0873832 Issue 05