Nortel CTA 500dm Installation Manual page 50

50 AT commands
Speech Bearer Call Answer Control
Result Codes
Audio Bearer Call Answer Control
Result Codes
CTA 500 dm On Line Guide
The Speech Bearer Call Answer Control Command
allows the CTA 500dm to accept or reject incoming calls received
over the speech bearer service.
The following table shows the values for speech bearer service calls
control.
Value
0
1
OK Sent if the selected value is understood.
ERROR Sent if the selected value is not recognized or is not
supported.
The Audio Bearer Call Answer Control Command
allows the CTA 500dm to accept or reject incoming calls received
over the 3.1 kHz audio bearer service.
The following table shows the values for 3.1 kHz audio bearer
service calls control.
Value
0
1
OK Appears when the selected value is understood.
ERROR Appears when the selected value is not recognized or is not
supported.
%A93=value
Speech Bearer Service Calls
rejected (default)
accepted
%A94=value
3.1 kHz Audio Bearer Service Calls
rejected (default)
accepted
P0873832 Issue 05