Table of Contents
Advertisement
12 Configuration
Configuring the PC serial port
Installing CTA 500 dm and Norstar TAPI Service Provider software
CTA 500 dm On Line Guide
¥ Verify the port baud rate is set to 115,200 (default) using the
Serial Interface Rate
¥ Set the character length, using the
parity, using the
Set Parity
no parity (recommended).
¥ Set the ßow control using the
default is hardware (recommended).
1. From the Norstar Personal Productivity Suite main screen, select
the Language, and then the Installation option.
2. After accepting the licensing terms and reading the TAPI
requirements (if displayed), select the Install option.
3. Select the CTA 500dm from the right hand side of the dialog box
(under the Drivers section).
4. On the left hand side of the dialog box, select the components
you wish to install:
Drivers Ñ the required drivers and conÞguration utility for the
CTA 500dm
Toolkits Ñ CTE, Norstar TAPI Service Provider (TSP)
Applications
5. Follow the on-screen instructions to select automatic
conÞguration, and to select the proper communications port.
6. Choose the appropriate settings for your installation.
command.
Set Data Bits
command. The default is 8 bits with
Flow Control
command and
command. The
P0873832 Issue 05
Advertisement
Table of Contents
