Nortel CTA 500dm Installation Manual page 21

Using PCM for the first time
P0873832 Issue 05
4. As the installation progresses, choose the appropriate options
and click the Next button as required.
5. Once the Setup Complete window displays, click the Finish
button. The program is installed and a PCM icon appears on the
desktop.
6. To access the program, double-click the PCM icon.
When the PCM software is installed, you need to choose a TAPI line
to enable PCM to use a TAPI-enabled device. You can change the
TAPI line at any time by choosing Dial Using from the Tools menu,
which calls up the Choose a TAPI line window.
1. Double-click on the PCM icon on the desktop. The PCM
program loads and the Choose A TAPI line window displays on
top of the program.
2. Use the pull-down menu to select the line for TAPI connection.
3. In the Address: box choose Default for a typical user
conÞguration or pull down the menu and select your line number
to use a speciÞc line for all calls.
4. Click OK.
5. After restarting your PC, Personal Call Manager is ready for use.
Note: Whenever you make a change in the Choose a TAPI Line
window (connection, address, or both), you must restart your
PC for the change to take effect.
Note: If your prime line is Intercom, you must have line pool access
codes in the Dialing Properties dialog box to make external
calls. These line pool access codes will be used for both data
and voice calls.
Installing Norstar TAPI SP 21
CTA 500 dm On Line Guide