Table of Contents
Advertisement
Call Monitoring Result Code Selection
Result Codes
S-registers
S-register commands summary
P0873832 Issue 05
The Call Monitoring Result Code Selection Command
controls the format of result codes sent by the CTA 500dm in
verbose mode during call setup. (See possible values in the
following table.) Values 1 and 2 are identical since the CTA 500dm
does not support dial tone detection.
Value
Result Code Operation
0
connect result code, no busy detection
1
connect rate result code, no busy detection
2
connect rate result code, no busy detection
3
connect rate result code, busy detection
4
connect rate result code, busy detection (default)
OK Appears when the value is acceptable.
ERROR Appears when the value is unacceptable.
The S-registers allow you to control CTA 500dm operation. The
registers are usually both read and write accessible. The registers
used vary with the application supported by the CTA 500dm. All
S-registers are saved as part of a CTA 500dm proÞle. S-registers can
appear as a group by using the &V command (see
page 35
for more information).
Command
Description
Sn=
set value to S-register
Sn?
query S-register value
X[value]
Value
depends on register
CTA 500 dm On Line Guide
AT commands 41
ÒGeneralÓ on
Advertisement
Table of Contents
