Nortel CTA 500dm Installation Manual page 29

P0873832 Issue 05
Use the following types of AT commands to communicate with your
CTA 500dm.
¥ ProÞle commands
¥ State commands
¥ General commands
¥ S-registers commands
¥ Call Control commands
¥ TCM Ports Protocol Selection
¥ MP commands
¥ Serial Interface commands
¥ Serial Interface Control Lines
¥ Calling Line ID commands
¥ Caller ID Security
To use an AT command, establish a HyperTerminal connection from
the PC to the CTA 500dm. Type the letters AT followed by the
desired AT command. For instance, the AT&V0 command queries all
stored CTA 500dm parameters.
You can string several AT commands into a single entry (for
example, AT &V0 S26 I4). The individual AT commands within the
string do not have to be separated by spaces (AT&V0S26I4 provides
the same information as the separated string in the previous
example).
AT commands
commands
commands
commands
CTA 500 dm On Line Guide