Installation / Connection To Services - Miele dgc 6805 Operating And Installation Instructions

Preparing the steam oven
Before installing and connecting the
steam oven to services please read
the chapter on "Plumbing".
Fit the water inlet hose
The water inlet hose is connected to the
back of the appliance, top left hand
side.
 Connect the end of the stainless steel
hose to the inlet connection.
Make sure it is screwed on correctly
and securely.
Fit the drain hose
The drain hose is connected to the
back of the appliance, bottom left hand
side.
 Connect the end of the plastic hose
to the appliance and secure it with
the hose clip.
Install and connect the steam
oven
A malfunction can occur if the steam
oven is not correctly aligned.
For correct functioning of the steam
generator please make sure that the
steam oven is horizontally level.
The maximum deviation tolerated is
2°.
 Connect the mains cable to the
appliance.
 Feed the water inlet hose and the
drain hose through the cut-out in the
base of the building-in niche.

Installation / connection to services

 Push the steam oven into the niche
and align it. Make sure that the mains
connection cable and water inlet and
drain hoses do not get trapped or
damaged when doing so.
 Secure the steam oven using the
wood screws supplied (3.5 mm x
25 mm) to the left and right hand
sides of the unit.
 Connect the appliance to the
stopcock and the drainage point (see
"Connection to the water supply" and
Connection to the drainage system").
 Connect the appliance to the
electricity supply.
 Check the appliance for correct
function in accordance with the
operating instructions.
185