Installation / connection to services
Preparation
Fit the water inlet hose
Fit the drain hose
Install and connect the appliance
172
Before installing and connecting the appliance to services
please read the section on "Plumbing".
The water inlet hose is connected to the back of the
appliance, top left hand side.
^ Connect the end of the stainless steel hose to the back of
the appliance.
Make sure it is screwed on correctly and securely.
The drain hose is connected to the back of the appliance,
bottom left hand side.
^ Connect the end of the hose to the appliance and secure it
with the hose clip.
^ Connect the mains cable to the appliance.
^ Feed the water inlet hose and the drain hose through the
cut-out in the base of the housing unit.
^ Push the appliance into position and align it.
Make sure that the mains connection cable and water inlet
and drain hoses do not get trapped or damaged when
doing so.
For correct functioning of the steam generator please
make sure that the appliance is horizontally level.
The maximum deviation tolerated is 2°.