Plumbing; Connection To The Water Supply - Miele dgc 6805 Operating And Installation Instructions

Plumbing

The water inlet and drain hoses must be
laid in such a way that the appliance
can be pulled out of its niche for service
work.
 Before connection, check the inlet
and drain hoses for visible signs of
damage.
Water inlet and drain hoses
– Stainless steel inlet hose
Length 1,500 mm (1.5 m) Ø 12.5 mm
Connection to stopcock and steam
oven both Ø 33.5 mm
– Plastic drain hose
Length 3,000 mm (3.0 m) Ø 12.5 mm
Connection to siphon Ø 26 mm /
Connection to steam oven Ø 15 mm
When laying the water inlet and drain
hoses through piping please make
sure the pipes have an internal
diameter of at least 50 mm.
186
Connection to the water
supply

Incorrect installation can result in
personal injury and damage to
property.
Connection to the mains water
supply should only be carried out by
a qualified and competent person in
strict accordance with national and
local safety regulations.
If connected to a domestic water
softening unit, please make sure that
the conductivity level of the water is
maintained.
All items used for connecting the
appliance to the mains water supply
must comply with the current
national and local safety regulations
in the country in which the appliance
is being installed.
The steam oven must be connected
to the cold water supply only.
The water inlet pressure must be at
least 100 kPa (1 bar) and not exceed
600 kPa (6 bar). If it is higher than
600 kPa (6 bar), a pressure reducing
valve must be fitted.
The stainless steel inlet hose
supplied must not be shortened,
extended or replaced by a longer
hose.
Old or previously used hoses must
not be connected to the appliance.
Before connecting the appliance to
the mains supply and after any work
on it, please flush the pipework
through to remove any deposits.