Motion Alarm - Eyemax TVST TR SERIES User Manual

Alarm
Buzzer: If selected, the local buzzer would be activated on an alarm.
Show Full Screen: If selected, there will pop up the chosen channel on the monitor on an
alarm trigger.
To Alarm Out: If selected, this would trigger external relay output on an alarm.
Email: If selected, the HD TVI Hybrid DVR will send an email alert to the preconfigured
email address in case of a sensor based alarm from the particular input.
Snap: If selected, the system will snap images of the checked channels on an alarm and save
them in the HDD automatically.
Go to "To Record" tab. Select recording channels. It would be recorded in case of an
⑦
alarm. Click OK button to save the setting.
Go to "To PTZ" tab. Set preset, cruise and track options for a PTZ in case of a sensor
⑧
based alarm. Single or multiple PTZ units could be programmed to perform this function
on the same alarm.
Go to "Schedule" tab. The setting steps for schedule for sensor based alarm are similar
⑨
to normal schedule setup. You can refer to Schedule Recording for details. This step is
very important for sensor alarm. Even if you have enabled the sensor alarm for all
channels and set up the trigger, you will not see the result of sensor alarm if no schedule
is added.
If you have set schedule for sensor based recording in the same timeline, recordings can also
be triggered.

9.2 Motion Alarm

Operate the following steps to configure motion based alarm:
Motion alarm includes two sub menus: motion and schedule. The steps to set motion alarm are
as follows:
①
Go to Main MenuSetupAlarmMotionMotion.
HD TVI Hybrid DVR User Manual
36