Eyemax TVST TR SERIES User Manual page 42

Alarm
②
Enable motion alarm, set alarm hold time which refers to the time till which the system
will wait for further detection of motion. e.g. If the holding time is set to 10 seconds,
once the system detects a motion, it will go to alarm but would not detect any other
motion alarm (specific to channel) until 10 seconds. If there is other motion detected
during this period it is considered it as continuous movement, otherwise it will be
considered as a single motion.
The setup steps of motion trigger are similar to "Alarm Handling" (See Sensor Alarm
③
Handling setting for more details).
④
After clicking Area button, a dialog box will pop up as below.
⑤
In the Area interface, you can drag slide bar to set the sensitivity value (1-8). The higher
the value is the more sensitive it is to motion. Since the sensitivity is influenced by color
and time (day or night), you can adjust its value according to the practical conditions.
Left click the grid and drag to delete area. Click
detection area. Click
sensitivity as per the local conditions. Once motion is sensed, it displays a figure icon.
Click icon to save the setting. Click
Note: Prior to setting motion detection field it is recommended that you click
icon to clear the existing field and set afresh.
icon to clear the set detection area. Click
37
HD TVI Hybrid DVR User Manual
icon to set the whole area as
icon to exit the current interface.
icon to test the