Table of Contents
Advertisement
The following explains how to load envelopes in the bypass tray using Monarch as an
example.
Important
• The reverse side of the envelope cannot be printed on.
• Envelopes can get wrinkled or the print quality is reduced depending on the type used. For details about
the usable envelope sizes, refer to "Usable Paper" (P. 28).
1.
In the case of Monarch, insert the
envelopes with the flaps open and at the
rear.
2.
Slide the paper guides to the size of the envelope.
Loading Transparencies
Important
• Transparencies with white frame and full-color transparencies cannot be used.
1.
After carefully fanning a small stack of
transparencies load them into the tray with
the side to be printed facing up. Load
transparencies a few at a time.
2.
Slide the paper guides to the size of the transparencies.
3.
Pull out the extension output tray when loading paper such as transparencies.
Printing on Envelopes/Transparencies
To print on envelopes or transparencies, display the [Tray/Output] tab and [Basic] tab. This
section explains the procedure using WordPad on Windows XP as an example.
Note
• When [Bypass Mode] is set to [Panel Specified], you need to set the paper type and size settings for the
tray on the control panel in advance. For details, refer to "Tray Settings" (P. 38).
• The way to display the printer properties dialog box differs according to the application software. Refer to
the manual of your respective application software.
• Printing transparencies continuously may lead to the output transparencies sticking to each other. As a
guide, remove the transparencies from the output tray after about 20 sheets and then fan them to lower
their temperatures.
1.
From the [File] menu, select [Print].
2.
Select this printer as the printer to be used and click [Preferences].
3.
Click the [Tray/Output] tab.
2.2 Printing on Envelopes/Transparencies
Printing side
Flap
Extension
output tray
Print face
23
Advertisement
Table of Contents
