Cleaning After Use; External Care; The Door And The Door Seal; The Control Panel - Sandstrom SID60W12N Installation Instructions Manual

Table of Contents

Available languages

Cleaning After Use

Clean the door seals regularly with a soft damp cloth to remove food deposits.

When the dishwasher is being loaded, food and drink residues may drip onto the sides of the dishwasher

door. These surfaces are outside the wash cabinet and are not accessed by water from the spray arms. Any

deposits should be wiped off before the door is closed.

If cleaning is required, the control panel should be wiped with a soft damp cloth ONLY.

• To avoid penetration of water into the door lock and electrical components, do not use a spray

cleaner of any kind.

• Never use abrasive cleaners or scouring pads on the outer surfaces because they may scratch the

finish. Some paper towels may also scratch or leave marks on the surface.

The filtering system in the base of the wash cabinet retains coarse debris from the washing cycle. The

collected coarse debris may cause the filters to clog. Check the condition of the filters regularly and clean

them if necessary under running water.

Follow the steps below to clean the filters in the wash cabinet.

1. Ensure the dishwasher is switched off.

2. Turn the coarse filter anti-clockwise and gently lift it out.

3. Rinse all the filters under running water, including the filter cylinder, and then refit all filters in the

reverse order.

4. Gently rescrew the coarse filter in clockwise direction. There will be a slight click when located correctly.

• Do not over tighten the filters. Put the filters back in sequence securely, otherwise coarse debris

could get into the system and cause a blockage.

• NEVER use the dishwasher without filters in place. Improper replacement of the filter may reduce

the performance level of the appliance and damage dishes and utensils.

* images are for indication only; please refer to your individual model for actual details.

Table of Contents