Mitsubishi Electric PURY-WP-YJM-A Data Book page 150

3. System remote controller
1. Specifications
(1). Device Specifications
Item
Power Supply 24 VDC 10%: 5 W (*1)
M-NET communication
Output
Interface
Input
Output
Input
Output Pulse Width
Interlock
Interlock M-NET devices and output contacts according to status of input contacts. (*8)
Function
Temperature
Environment
Conditions
Humidity
Dimensions 200 (W) × 120 (H) × 45 (D) mm / 7
Weight 0.6 kg / 1
Time Backup
In the event of power failure or shut-off, the internal capacitor will continue to track time for approximately one week.
During Power
(The internal capacitor takes about 24 hours to fully charge; a replacement battery is not necessary.)
Failure
Installation Inside the metal control board (indoors)
Environment * Use this product in a hotel, a business office environment or similar environment.
*1: For details, refer to "1-(2). Parts Purchased Separately".
*2: Supply electric power from a power unit for the transmission line or an outdoor unit.
Furthermore, the power consumption factor of the M-NET circuitry of this device is "1/4" (equivalent to one ME Remote Controller).
*3: Non-voltage Relay contact or transistor is available for output. Only one can be used at a time.
*4: ( ) is in the case of a pulse.
*5: The output is open collector type. Power must be supplied from an external power source to the output circuit of this device.
*6: Power is supplied from this device to the external contacts.
*7: Power must be supplied from an external power source.
*8: M3 and M3.5 are sizes of the screw on the terminal block (ISO metric screw thread).
The number indicates the screw diameter (mm).
17 to 30 VDC (*2)
Non-voltage Relay contact (2)
ON/OFF,
(ON)
(*4)
(*3)
Non-voltage Relay contact (2)
(OFF)
(*4)
ON/OFF
Non-voltage a contact
Error/Normal
ON/OFF, (ON)
(*4)
Transistor (4 each)
(OFF) (*4)
ON/OFF
24 VDC input (4 each)
Error/Normal
Operating temperature range
Storage temperature range
30 to 90%RH (no condensation)
7 / (W) × 4
8
3 / lbs
8
CONTROLLER
Rating and Specification
Applied load
MAX: 24 VDC, 5 W
MIN: 5 VDC, 2 mW
* AC loads cannot be
connected.
24 VDC 40 mA or less
Transistor (2)
Applied load
MAX: 24 VDC, 5 W
MIN: 5 VDC, 2 mW
* AC loads cannot be
connected.
24 VDC 40 mA or less
Transistor (2)
24 VDC 1 mA or less
(2 each)
24 VDC 40 mA or less
24 VDC 1 mA or less
1s 30 ms
0 to 40
-20 to 60
3 / (H) × 1 25 / (D) in
4 32
Screw terminal block
(M3) (*8)
Screw terminal block
(M3) (*8)
Screw terminal block
(M3.5) (*8)
Screwless terminal
(*5) block
Screw terminal block
(M3.5) (*8)
Screwless terminal
(*5) block
Screwless terminal
(*6) block
9 pin connector
(*5)
9 pin connector
(*7)
1s 30 ms
[32 to 104 ]
[-4 to 140 ]
3 - 65