Mitsubishi Electric PURY-WP-YJM-A Data Book page 120

3. System remote controller
4. LAN connection function
Connect the LAN cable to the LAN connector of this device.
Procure the LAN cab le at the site, and use an enhanced category 5 UTP cable.
For a description of the IP address setting method, refer to Installation Manual.
LAN is 100 BASE-TX Specification.
The maximum wiring length from HUB to GB-50ADA is 100m [328ft].
GB-50ADA is connected to the monitoring PC via HUB.
NOTE
Perform the LAN wiring before installation, and wire up to the body by the same method as wiring the M-
NET transmission line.
When a LAN is already connected, decide the IP address by consultation with the system administrator and
connect to the LAN body after changing the IP address.
Space f or the connector and wiring is required. Refer to Installation Manual.
Connect GB-50ADA to a private network.
Use a security device such as a VPN router when connecting the GB-50ADA to the Internet to prevent
unauthorized access.
(If no security devices are installed, the operation settings may be changed by an unauthorized person
without the knowledge of the user.)
CONTROLLER 3 - 35