On-Board Battery Charger - Invacare Pronto M91 User Manual

8 WHEELCHAIR OPERATION
8.8

On-Board Battery Charger

WARNING
AFTER charging batteries, ALWAYS make sure that the battery charger cord is securely wrapped and stored within the
hook and loop strap assembly on the rear of the battery tray. Failure to do so may result in damage to the cord or personal
injury tot he user or bystanders.
Ensure the pins of the extension cord plug are the same number, size, and shape as those on the charger.
For this procedure, refer to FIGURE 12 on page 67.

Charge indicator light is only visible with rear shroud removed.
1. Plug the female connector of the AC power cord (supplied) to the AC receptacle on the charger and plug in the male connector on the AC
power cord into the wall outlet.
2. The On/Off LED indicator illuminates solid RED indicating that the charger is On.
3. If the On/Off LED indicator is "Blinking" RED, this is abnormal. Unplug AC power cord from the on-board battery charger and wall outlet.
Contact Invacare at the number listed on the back page of this manual.
4. When the On/Off LED indicator light is Off, charger is Off.
5. When the Charge LED indicator light is YELLOW, the batteries are charging.
6. When the Charge LED indicator light is solid GREEN, the batteries are fully charged (as their condition will allow). At this point, the charger
automatically stops charging.
7. When charging is complete, unplug the male connector of the AC power cord from the wall outlet and then unplug the female connector of the
AC power cord from the AC receptacle on the charger.
WARNING
DO NOT operate wheelchair with AC power cord attached to the wheelchair.
Invacare® Pronto® M91™
66
Part No 1143153