Table of Contents
Advertisement
I) ASSEMBLE & ATTACH THE SHROUD
Shroud assembly includes:
Loosen and remove the nuts attached to the upper grill.
1.
Place the upper grill rods through the holes in the shroud top
piece and secure with the nuts (A). NOTE: The louvers on
the grill should be in the downward position.
2. Secure the right and left shroud pieces to the top piece by
aligning the (2) holes in the side pieces to the holes in the top
piece. Secure with the screws provided (2 ea. side) (B).
NOTE: Screws are secured from the bottom.
3. Snap the rocker switch in place on the shroud. Figure H-2.
4. Slide one connector on one end of each rocker switch wire to
the rocker switch terminals.
ATTACH THE SHROUD
OUTSIDE FIT APPLICATIONS:
OUTSIDE FIT APPLICATIONS:
1. Attach the shroud to the fireplace by inserting the tabs (A) on
the left and right shroud pieces to the holes (B) in the face of
the fireplace. The shroud will set down into place. Figure H-3.
CONNECT THE ROCKER SWITCH WIRES TO THE VALVE.
Slide the remaining connectors on the rocker switch wire
to the top and bottom terminals marked 'TH' on the valve.
(1) Shroud top
(1) Shroud left side
(1) Set (1 left & 1 right) 'inside fit' brackets.
Additional Items Needed:
(1) Shroud right side with on/off rocker switch mounting hole
(8) Screws
Rocker switch & wires from the fireplace components packet.
Upper grill (grill set sold separately)
Snap On/Off rocker switch into
mounting hole as shown.
Figure H-2
Figure H-3
PAGE 16
Figure H-1
Advertisement
Table of Contents
